Tips for Replacing a Garbage Disposal .
Occasionally, even the best care and maintenance can stop a garbage disposal out of breaking up down. However, with proper tools, installing a new one is going to be simple and stress-free. The question however is, how do you know when to replace your garbage disposal? Well, when you flip the switch to turn on the garbage disposal and all you get is a loud, metal on metal grinding sound, then you need to be aware that something is amiss. The fantastic news is that replacing a garbage disposal does not require you to have a degree from a renowned university in Rocket Science. Even if you haven’t done much plumbing, you will be able to handle it because it is a trouble-free process that any patient person could successfully handle. This article is majorly going to talk about how you should replace your garbage disposal without the help of a professional.
The very first thing you need to do would be to get ready for the job ahead of you. It’s prudent that you have all the parts listed on the instruction sheet to prevent destructions once you start the project. What follows must be turning off the ability to the disposal in the circuit -breaker box. Among the most important things you shouldn’t forget to do is to check the amperage off the circuit so as to be certain the disposal won’t overload it. Once all that is done, you must disconnect the drain from the disposal unit with the use of pliers so as to loosen the spring clamp holding the dishwasher drain tube in place. Following that, you must remove the drain tube in the device and proceed to the next step.
Secondly, you should consider taking out the disposal unit. The best way to do so is by twisting it off of the mounting nut as you dump out any remaining water and debris. What follows is that you ought to turn the device upside down with the only purpose of removing the plate covering the electric connections. After that’s done, you must remove the grounding cable and screw nuts so as to pull the cable out of the device. You should take note that if your disposal is the same as the old unit, there will be no need to replace the mounting hardware. If that is not the case, you will have to eliminate the existing mounting assembly so as to drain.
This step should be to install the hardware at which you’ll have to place a rubber seal on the underside of the drain flange. You will then need to attach the mounting ring with threes screws and twist it before the meeting is even and tight enough. Finally, you’ll have to prepare the newest disposal so you complete the installation.